Remove the radiator cap A , wet its seal with 1. Make sure it locks in place. If you are not wearing a seat for a forward-facing child seat, the improperly in the front seat can belt in a crash, you could be. Remove the cylinder head cover see page 6-34. Letters or bars have been stamped on the 1. Power is not transmitted to the countershaft.
Disconnect the connectors from the mainshaft and countershaft speed sensors. If the engine is still in the vehicle, drain the engine oil see page 8-5. Use the proper liquid sealant. Then push and release Remote Transmitter the door is unlocked. D4 Indicator Detection Item Page P0715 15 Blinks Mainshaft speed sensor see page 14-70 P0720 9 Blinks Countershaft speed sensor see page 14-72 P0730 41 Shift control system. Insert the new bulb into the hole, Turn Signal and Parking Light making sure the tabs are in their Bulb slots.
A sunlight sensor is located in the top of the dashboard and a temperature sensor is next to the steering column. Tighten the bolts and nuts sequentially in two or three steps. N Position Engine power transmitted from the torque converter drives the mainshaft idler gear, the countershaft idler gear, and the secondary shaft idler gear, but hydraulic pressure is not applied to the clutches. Install the bearings A and bearing caps B with 12. When worn or area damaged At 2nd gear 39.
Sistema de Medición y Testigos de Alerta encontrar. The light above the button should come on when a fan speed is selected. Using a ring expander A , remove the old piston rings B. Apply new engine oil to the threads and flanges of 9. Some air will flow from the dashboard corner vents in all modes.
Model Year X: 1999 b. Remove the oil screen A , baffle plate B , and oil pump C. With the battery positive terminal still connected to 24. Disconnect the wires from the S terminal and the 5. Apply vacuum to the hose with 5 strokes of the pump. Install the upper radiator hose A and lower 24. Rear Window Wiper and your Honda.
Remove the connecting rod cap and bearing half complete bearing with the same color code, and see page 7-12. Warm up the engine to normal operating temperature the radiator fan comes on. Install the oil pan on the cylinder block. Remove the bolt securing the mainshaft speed sensor, then remove the mainshaft speed sensor from the end cover. Remove the front upper cover.
Place a shop towel under the fuel pressure regulator, then relieve the fuel pressure see page 11-215. Monitor the voltage for 20 seconds. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term. Drain the fuel tank: Remove the fuel tank unit see page 11-230. Place the cap in the holder on the fuel fill door. Measure the voltage between the 2nd clutch securely supported. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability.
A seat that is not locked in place could fly around and cause injury in a sudden stop or crash. Service at the indicated distance or time, whichever comes first. Disconnect the 3P connector from the lock-up 11. Power is then transmitted through the engaged clutch pack to its hub-mounted gear. Check total runout with the camshaft supported on 12.