A liftgate is the device that lowers a product from the truck to ground level. Move the cap and harness aside. Attach the compressor block adapter from the flushing kit to the system side of the compressor block. Insufficient refrigerant flow to 1. Connect the filter housing to the desired return side Automatic of the adapter block and to the blue low-side hose. The machine is equipped with special connectors to recover, recycle, and recharge only R1234yf refrigerant.
Remove the filter by turning it counterclockwise as viewed from the bottom of the filter. Remove the cover on the printer by pulling out on the tab as shown in Figure 26. The machine stops when the specified amount of time has elapsed. The use of this machine under normal environmental conditions 10°C to 50°C keeps pressures under reasonable limits. No stopping to fill the internal tank during service, or before service.
Refer to Figure 20, and verify the magnet on the bottom of the machine is clean. Do not use in open air in case of rain or high humidity. During the vacuum vacuum process. Air flow is Exit current test. Note: If a source tank is connected to the tank fill hose while the machine is sitting idle, the machine automatically adds refrigerant up to the level set during Tank Fill Adjustment. First ensure that pressure does not exist in the line.
This file contains the all of the information through Appendix E referenced in the table of contents. Hang the shroud on the back of the machine as Figure 16 shown in Figure 16. Hose couplers Transportation of Equipment connected to storage ports. Figure 20 the scale is out of calibration. Filter Housing Disassemble the 2. We recommend you have the additional help of two to four people to move the product to its desired location because drivers are not required to assist.
Refer to Tank Fill Adjustment in the Change the default charge amount that appears Maintenance section. Position the machine far from heat sources, such as direct sunlight, which can cause excessive temperatures. All inspection costs are the responsibility of the Buyer and a refundable deposit is required. Install Oil Drain Bottle 1. Press the Menu key to exit the keyboard and move to the next fill field. Refer to Replace the Filter in the Maintenance section. A representative from the freight carrier will call the phone number entered at checkout to schedule the delivery.
If a Seller has sold an Item, BoE will try to assist in locating another unit. Start the 25700 and run a recovery according to instructions supplied with the machine. Accessory Kit Calibration Weight Tank Fill Hose 533 g Adapter Vacuum Pump Oil Cap and Filler Tube 16 oz. Requesting liftgate service after ordering may result in additional charges and delays. Install the new roll of paper with the end of the paper at the top of the roll.
Note: The date changes only by scrolling through an entire day. Note: The tank fill hose and the tank access port have left-hand threads. The cursor will move to the next character. Refer to the vehicle service manual for specific vehicle instructions. Please see below for Appendix F and Attachments A through E. The default display is remaining until the machine locks down and no kilograms.
Please review the updated and accept changes. No stopping to fill the internal tank during service, or before service. This file contains the all of the information through Appendix E referenced in the table of contents. Freight Orders Freight deliveries require a delivery time be scheduled and someone must be present at the time of delivery to inspect and sign for the merchandise. If pressure greater than 0. Buyers pay a commission in addition to the accepted offer.